Roof Anchors – Cast In Place – 1 Piece Fully Embedded

The standard height of a fully embedded roof anchor is 18 and 24 inches.
This anchor suits all 3-1/2 inch conventional flashings.
Using a fully embedded anchor is more cost-effective than a single stud or a four-stud anchor of the same finished height.
The base Plate of this anchor MUST sit on top of the bottom reinforcing bar.
The general contractor must provide the bottom re-rod steel location and the slab thickness at each anchor location to determine the total anchor height.

Download the Permanent Roof Anchor Brochure to review specifications, load ratings, and installation details.

Product size variations are listed below.

For project-specific guidance or system design support, contact our team.

Description

Fully embedded one-piece roof anchor developed for cast-in-place concrete applications
Flat base design makes the anchor easier to position for casting than comparable stud-supported configurations
More economical than single-stud and four-stud roof anchors when comparing the same finished anchor height
Compatible with 3-1/2 inch conventional flashing and offered in a range of heights to accommodate project requirements

Designed to be incorporated directly into the concrete slab, with the anchor base plate installed on top of the bottom reinforcing bar.

Below is a chart of our standard sizes. More are available upon enquiry.